Hello.
I have a problem with adding a hardware shutdown button. I am using a CM4 module and my own expansion board.
I have modified the config.txt file by adding
dtoverlay=gpio-shutdown
gpio3 pulled up to 3.3V, button between gpio3 and ground.
Moode Audio 9.1.4 no reaction to pressing the button. When I change the SD card with another system, the system shuts down after pressing the button. Pressing it again restarts the system, so I assume the hardware is OK.
I also tried to enable button support in the Moode settings, without success. I also changed the gpio pin, without effect.
I have a problem with adding a hardware shutdown button. I am using a CM4 module and my own expansion board.
I have modified the config.txt file by adding
dtoverlay=gpio-shutdown
gpio3 pulled up to 3.3V, button between gpio3 and ground.
Moode Audio 9.1.4 no reaction to pressing the button. When I change the SD card with another system, the system shuts down after pressing the button. Pressing it again restarts the system, so I assume the hardware is OK.
I also tried to enable button support in the Moode settings, without success. I also changed the gpio pin, without effect.
