ProtoDAC TDA1387 X8 project

[Tim Curtis]

Thank you, it works and sounds very good. It was a sw config mistake on my part. Using CamillaDSP for Polarity Inversion and flat dithering at 16 bit at the moment.

When Camilla Polarity/Flat dithering implemented, CamillaDSP takes over volume control. I control volume on my vintage Arcam integrated so to bypass CamillaDSP volume control, do I set it for 100 volume and go control it on the integrated amp? Just trying to minimize volume control chain.

Thank you again for all the help making it. Another donation is coming.

Glad it's working :-)

To switch to fixed volume output do the following:

Menu > Configure > Audio
Set Volume type to "Fixed (0dB)"

This setting results in MPD outputting 0dB (no attenuation).