12-27-2024, 07:12 PM
(This post was last modified: 12-27-2024, 08:10 PM by Tim Curtis.
Edit Reason: mark solved
)
I bought a new pi to run an old Zenith console. Wanted to see if the Apply USB dongle would be good enough for temporary. Not sure how to setup USB? It's not in any of the Audio Output drop downs I can see (scanning output only shows HDMI) - googling brings up REALLY OLD posts for usb.
I'm sure I'm missing something really obvious but what? Do I need a driver or ??
I'm sure I'm missing something really obvious but what? Do I need a driver or ??
Code:
usb-devices|grep 'T:\|S:'
T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=480 MxCh= 1
S: Manufacturer=Linux 6.6.51+rpt-rpi-v8 dwc_otg_hcd
S: Product=DWC OTG Controller
S: SerialNumber=3f980000.usb
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=480 MxCh= 4
T: Bus=01 Lev=02 Prnt=02 Port=00 Cnt=01 Dev#= 3 Spd=480 MxCh= 3
T: Bus=01 Lev=03 Prnt=03 Port=00 Cnt=01 Dev#= 6 Spd=480 MxCh= 0
T: Bus=01 Lev=03 Prnt=06 Port=01 Cnt=01 Dev#= 4 Spd=480 MxCh= 0
S: Manufacturer=SanDisk
S: Product=Firebird USB Flash Drive
S: SerialNumber=4C532000011207102505
T: Bus=01 Lev=03 Prnt=04 Port=02 Cnt=01 Dev#= 5 Spd=12 MxCh= 0
S: Manufacturer=Apple, Inc.
S: Product=USB-C to 3.5mm Headphone Jack Adapter
S: SerialNumber=DWH43640134JKLTAD