(01-04-2025, 08:49 PM)hifinet Wrote: Hi @speedy210 speedy210
I am using the 3.3uF Superior-Z and they fit, but extend off the edges of the HAT due to the large diameter. Dimensions are 30mm x 45mm. Great sounding caps. The best I have tried.
10uF are 46mm x 70mm (too big). 3.3uF are the largest that will fit. The next highest value of 3.9uF are 30mm x 57mm.
@hifinet Thank you very much for your answer. The fact that they survive would not bother me at all. I have installed everything in an amplifier housing. Ok, you can bend the pins or wires then. The capacitors are still quite solid.
Something else, I found these resistors at Digikey. Are these the TX2575? It's difficult to get hold of them.
https://www.digikey.de/de/products/detai...9L/2609886