Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Newbee - Use Moode on "pur" RPi 3B+
#11
@Sniglar

I haven't had time to explore what the "right" answer should be, but I have a hack which works.

I received the WMA files you sent. I repro'ed your experience trying to play them over BT to my JBL speaker. 

I was, however, able to play them by turning on SOX resampling with the setting 16bit/*kHz. (When I went back to the MPD settings later, it showed 16bit/88.2 kHz)

Here's moOde's "Audio info" for the first track

Code:
INPUT PROCESSING
Source:     SDCARD/4 Non Blondes WMA/What's Up- [UK CD Single]/01 What's Up-.wma
Encoded at:     bit, 44.1 kHz, Stereo, WMAV2
Decoded to:     24 bit, 44.1 kHz, Stereo, 192 kbps
DSP OPERATIONS
Resampling:     n/a
Crossfeed:     n/a
Equalizer:     n/a
Crossfade:     n/a
Other:     n/a
Chip options:     none
Volume ctl:     Software (MPD 32-bit float with dither)
OUTPUT STREAM
Destination:     Bluetooth
Encoded at:     16 bit, 44.1 kHz, Stereo, 1.411 mbps
AUDIO DEVICE
Device:     On-board audio device
Chip:     Broadcom SoC
Interface:     SOC

Curiously, the "Encoded at:" line doesn't report a bit-depth, which according to mediainfo is 16-bit.

Maybe someone better versed in the decoding/resampling technology can shed some light on this. Otherwise, I have to hit the books.

Regards,
Kent
Reply


Messages In This Thread
Newbee - Use Moode on "pur" RPi 3B+ - by UpsiUps - 11-29-2018, 07:59 AM
RE: Newbee - Use Moode on "pur" RPi 3B+ - by TheOldPresbyope - 01-02-2019, 06:35 PM

Forum Jump: