02-07-2019, 07:30 AM
(02-07-2019, 12:42 AM)rahul.shial Wrote:(02-06-2019, 11:51 PM)rikardo1979 Wrote:(02-06-2019, 10:41 PM)rahul.shial Wrote:(01-13-2019, 09:42 PM)Tim Curtis Wrote: lol.
After you open the UI in a Browser, the open the System config page and scroll down to the section "Local Display"
Hi Tim,
I am an absolute novice when it comes to headless versus head projects...I downloaded the Moode image and imaged a microsd card. However if when starting the raspberry pi, if the display will not work, how do I open the UI and configure Moode? Sorry for asking such a stupid question..
Regards
Rahul
Did you read the setup guide? Please read through.
You connect to moode not from the Raspberry you installed it on but from any other computer or any device with web browser. If you know the IP address use that or use http://moode.local
You find all the info in the guide http://moodeaudio.org/forum/forumdisplay.php?fid=15
Hi Ricardo,
DUH moment for me...I did read, but failed to understand. It's been too long I've been away from any type of networking or unix...getting old... Thank you so much...it works perfectly now.
However I have another question - if I store all music on a USB, how do I get it to always play directly from the USB and not look anywhere else for music? This will be another DUH moment for me....Thank you so much in advance!!!
Again... read the 'setup' info... and forget about Unix or anything else, just follow the information in the text...
From the setup guide:
<< (line 69) 2. AUDIO DEVICE SETUP
- USB DEVICE
a) Menu, Configure, Audio, I2S audio device: None
b) MPD options: EDIT SETTINGS
c) Leave Volume control set to "Software"
d) Set Audio device to "USB audio device" then APPLY
>>
