04-21-2019, 11:46 AM
Yes it sounds good to me, enough for thinking of buying records only, no more gear =)
Here you are:
For LP playback a Thorens TD-318 with an Ortofon Super OM 20, RCA interconnects were changed and the inner platter is the metal one of the TD-320; still have to refurbish the electronic and super-fine adjust the speed,
a Pacific RIAA pre, freq. response tuned for my Ortofon cart and custom low noise low current PSU,
a TEAC VRDS-10 as CD transport, DAC board is no more, new PSU for servo drivers, top Tentlabs clock/clock PSU, digital supply lines cleaned, new TTL to S/PDIF output board,
a RPi with Allo DigiOne with the official SMPS (a Salas L-Adapter later), moOde 5 of course
,
the DAC is the not finished case under the TV set, but fully enjoyable as is, it's a TPA Buffalo II, clean PSUs, class A output stage being a NTD1 v4 with polystyrene coupling caps, S/PDIF only for now, (better top S/PDIF than bad I2S),
amp is a dual mono Hypex UcD400HG HxR DC coupled,
and last but not least the sleeper speakers: JBL 4313B "enhanced" with charge-coupled crossover and custom made tweeters based on JBL factory's recommendation of swapping old 066 to 035Ti, hence their nickname 4313Ti. They are often mistaken for "party" speakers à la L100 or 4312, but they ain't. Killer speakers for an average size room (20 m2 here).
I guess you know all the story now =)
Here you are:
For LP playback a Thorens TD-318 with an Ortofon Super OM 20, RCA interconnects were changed and the inner platter is the metal one of the TD-320; still have to refurbish the electronic and super-fine adjust the speed,
a Pacific RIAA pre, freq. response tuned for my Ortofon cart and custom low noise low current PSU,
a TEAC VRDS-10 as CD transport, DAC board is no more, new PSU for servo drivers, top Tentlabs clock/clock PSU, digital supply lines cleaned, new TTL to S/PDIF output board,
a RPi with Allo DigiOne with the official SMPS (a Salas L-Adapter later), moOde 5 of course
,the DAC is the not finished case under the TV set, but fully enjoyable as is, it's a TPA Buffalo II, clean PSUs, class A output stage being a NTD1 v4 with polystyrene coupling caps, S/PDIF only for now, (better top S/PDIF than bad I2S),
amp is a dual mono Hypex UcD400HG HxR DC coupled,
and last but not least the sleeper speakers: JBL 4313B "enhanced" with charge-coupled crossover and custom made tweeters based on JBL factory's recommendation of swapping old 066 to 035Ti, hence their nickname 4313Ti. They are often mistaken for "party" speakers à la L100 or 4312, but they ain't. Killer speakers for an average size room (20 m2 here).
I guess you know all the story now =)
