[How to do instruction] Easy installation / setup / configuration guide for absolute beginners

[rahul.shial]

What plug connection are you using to adapt the headphones/speaker to the Pi ? (Pi 3.5m plug has shared audio and video and a 4 ring connector so )
https://www.raspberrypi-spy.co.uk/2014/0...ideo-jack/

If you have the hdmi monitor connected AND want audio via the 3.5 m plug instead of through the HDMI and monitor's speakers then you will have to make changes as per this....
https://www.raspberrypi.org/forums/viewt...p?t=174438

The touchscreen on the pi is slower than using it headless,  yes this is normal.

That doesn't make sense to me at least. I have another raspberry pi 3 connected to extremely old altec lansing speakers playing mp3 songs off the microsd card using mplayer or something, and it is a headless unit. However the same speakers will not work with the MoOde player on the 2nd raspberry pi. so this is definitely confusing for me..

I am happy again...Thank you Drone...the raspi-config worked like a charm...luv ya guys and gals out here...so much of help available...Thank you once again..

[rahul.shial]

What plug connection are you using to adapt the headphones/speaker to the Pi ? (Pi 3.5m plug has shared audio and video and a 4 ring connector so )
https://www.raspberrypi-spy.co.uk/2014/0...ideo-jack/

If you have the hdmi monitor connected AND want audio via the 3.5 m plug instead of through the HDMI and monitor's speakers then you will have to make changes as per this....
https://www.raspberrypi.org/forums/viewt...p?t=174438

The touchscreen on the pi is slower than using it headless,  yes this is normal.

That doesn't make sense to me at least. I have another raspberry pi 3 connected to extremely old altec lansing speakers playing mp3 songs off the microsd card using mplayer or something, and it is a headless unit. However the same speakers will not work with the MoOde player on the 2nd raspberry pi. so this is definitely confusing for me..

I am happy again...Thank you Drone...the raspi-config worked like a charm...luv ya guys and gals out here...so much of help available...Thank you once again..

Just to update - the setup is working like a dream, and the touch response is pretty decent on the touchscreen while using MoOde..Thank you all for the most wonderful support.

[olivier.drean]

I think there is a typo :
ssh file should be set on the "boot" partition (not the "root" partition).

Regards

[wusa88]

Started a new thread..

[mrdrew]

@deztiny following your excellent guide here. Small change at the end of Step 5:

Wait for about 10 seconds until the green LED on Pi stops blinking. Then unplug the power cable AND keyboard (its not needed anymore).

6. Installation & progress status
Plug in the Raspberry PI and wait.

[deztiny]

@deztiny following your excellent guide here. Small change at the end of Step 5:

Wait for about 10 seconds until the green LED on Pi stops blinking. Then unplug the power cable AND keyboard (its not needed anymore).

6. Installation & progress status
Plug in the Raspberry PI and wait.

Done