undervoltage detected

[Olive]

Hello I have installed a new SD card with moode 8 ; but during installation I have "undervoltage detected"
It was not the case before this new install and I changed power supply and power wiring with same result.
Can you help me please?

[Nutul]

Hello I have installed a new SD card with moode 8 ; but during installation I have "undervoltage detected"
It was not the case before this new install and I changed power supply and power wiring with same result.
Can you help me please?

Hi,

what does it mean "during installation"? You should write the SD card on your PC, and there you won't get any such message.


- If you get this during boot / startup then check what is connected to your RPi, especially external USB devices.
- Do you use any HAT, like a DAC for instance, or an AMP?

It was suggested you made a fresh 8.3.7 installation on a new SD card using Raspberry Installer; did you do it?

I'd recommend then, to boot your Pi without any external accessory, and see if it boots normally. Then, add the USB devices (again, if any) one by one, and after each one do a reboot and watch for "undervoltage" messages.

[Olive]

Thanks,
It seems it works now. But I can't connect with ethernet. Neither with http://moode nor moode.local. How can I know the IP adress please?
Thanks

[fdealexa]

Hi Olive,
please try with the program Advanced IP Scanner at this LINK, (it discover the IP Address of all devices connected on your network).

Best regards,
Francesco