[PROBLEM] Holo Red issue to configure MoOde

[JoJoJo]

Hi, I’m new to this forum and MoOde. I bought a Holo Audio Red with its Red OS but would like to change to MoOde with Rigelian and Qobuz integration. I flashed a SD card and can access MoOde from PC and iPad but cannot change the renderer settings to UPnP for MPD. 

Any ideas how to solve this?

Frank

[TheOldPresbyope]

Hi, I’m new to this forum and MoOde. I bought a Holo Audio Red with its Red OS but would like to change to MoOde with Rigelian and Qobuz integration. I flashed a SD card and can access MoOde from PC and iPad but cannot change the renderer settings to UPnP for MPD. 

Any ideas how to solve this?

Frank

"...flashed a SD card..." is vague. Specifically, did you use the official Raspberry Pi Imager tool and, in it, did you set a username and password in the OS Customization section (and maybe check as well that the SSH service is enabled with password authorization) before you actually flashed the card? All this is spelled out in the Setup guide.

Regards,
Kent

[JoJoJo]

Hi, I followed Holo Reds instructions and used Balena Etcha Portable

Frank

[TheOldPresbyope]

Hi, I followed Holo Reds instructions and used Balena Etcha Portable

Frank

Balena...sorry, that won't work unless you take an extra step BEFORE you first boot that SD card. See my post in FAQ and Guides section.

Regards,
Kent

[JoJoJo]

Thank you, so I will try with official tool again.

[Jinxy]

Thank you, so I will try with official tool again.

Hi,

I have a Red, running Moode. Works very well.

Let us know how you get on.

[Falco]

I do not have solution, hope you could get your issue fixed by flashing the SD card via the official endorsed method.

I just wanted to comment on the Holo Audio Red itself, interesting piece of equipment, did not know it exists...

Using a RPi compute module seems such a good way for these type of hardware. I only knew of the USBridge Signature Player doing this, but apparently there are more. Interesting!