Thank you for your donation!


Instruction Guide trying to use Moode 7
#1
Hi,
I have the (old) Moode 1.0 on my Raspberry since years
So I have downloaded Moode 7.2.0.
I put the iso file on a new micro SD and then put it in the raspberry. I boot up and.. nothing.
Fortunately I kept my old micro SD and Moode 1.0 still works.
Could you help me please?
Thank you.
Olivier
Reply
#2
(05-01-2021, 03:27 PM)Olive13 Wrote: Hi,
I have the (old) Moode 1.0 on my Raspberry since years
So I have downloaded Moode 7.2.0.
I put the iso file on a new micro SD and then put it in the raspberry. I boot up and.. nothing.
Fortunately I kept my old micro SD and Moode 1.0 still works.
Could you help me please?
Thank you.
Olivier

Olivier, probably been quite a while since you last wrote an image to an SD card.
You say you loaded the iso to the SD card, the correct method is to use an image writer such as Balena Etcher or raspberry Pi imager to unzip and write the downloaded (iso) files to the SD card. Have you referred to the Setup Guide help thread?
If that does not work, a bit more info on your hardware might help, RPi model and the devices connected to it might help diagnose the problem.

Ian
Reply
#3
Hi Ian, it works perfectly with Balena Etcher. Thank you very much for your essential help!
All the best.
Olivier
Reply


Forum Jump: