[SOLVED] Hifiberry Digi2 Pro coax output

[tigm97]

Hello,

I have recently acquired a hifiberry digi2 pro and a rasberry pi4b. I have it connected via ethernet and am able to successfully connect by going to https/moode. My issue is that when it comes to choosing an l2s device the board is not one of the available options and I have tried selecting some of the other digi boards but have been unable to get it to output via coax. Any help would be much appreciated.

Thanks,

[JoseMR]

Hello,

I have recently acquired a hifiberry digi2 pro and a rasberry pi4b. I have it connected via ethernet and am able to successfully connect by going to https/moode. My issue is that when it comes to choosing an l2s device the board is not one of the available options and I have tried selecting some of the other digi boards but have been unable to get it to output via coax. Any help would be much appreciated.

Thanks,

Hello, I don't own Rpi4 nor the Digi2 Pro but if you don't see the device name nor the overlay under the supported devices, you may try adding/configure it manually and test if it works.

Here is the Digi2 Pro Datasheet

From Datasheet:
Configuration
Overlay for config.txt:

Code:

dtoverlay=hifiberry-digi-pro

Regards

[Tim Curtis]

Hello,

I have recently acquired a hifiberry digi2 pro and a rasberry pi4b. I have it connected via ethernet and am able to successfully connect by going to https/moode. My issue is that when it comes to choosing an l2s device the board is not one of the available options and I have tried selecting some of the other digi boards but have been unable to get it to output via coax. Any help would be much appreciated.

Thanks,

Choose the DT overlay for the board.

   

[tigm97]

Thank you both for the help, much appreciated, all set up and working now! Apologies for the basic question, new to this.