The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 906 - File: showthread.php PHP 7.2.34 (Linux)
File Line Function
/showthread.php 906 errorHandler->error



Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Solved: No Access Point
#1
Hello, 
I am totally new with moode audio. A came from Volumio an loved its ready-to-use Access Point - feature.
I really want to use Moode Audio offline on a music festival but unfortunately, the AP-Mode is not working on my Moodeaudio- image.

My Hardware- Setup:
  • Raspberry 3 B+
  • SanDisk Micro-SD-Card (32 GB) for the Moode Aduio- image
  • SanDisk Micro-SD-Card (16 GB) for the Rasbian Stretch Lite- image

I have done the following steps:
  1. Installed Stretch Lite on my 16 GB Micro-SD
  2. Started my RasPi with it.
  3. Entered the commands from the support-page moodeaudio.org via SSH (Putty)
  4. I configured it this way:
    - no proxy- WLAN connection (SSID and PW from my WLAN- router at home)- install image on USB- device (my 32 GB card was plugged in with a cheap usb-sd-adapter)- no backup image
  5. Installation was completed after a while
  6. Inserted new moode -sd card into my RasPi
  7. After a while, i was able to reach the Moode Audio- configuration- site with Chrome
  8. Navigated to network- page
  9. Removed SSID there ("AP-Mode enabled")
  10. Reboot
I have waited for a while, but no access point "Moode" was found with my smart phone.
Do you have any suggestions?

Thanks a lot,
Sascha
Reply


Messages In This Thread
No Access Point - by paradox - 04-12-2018, 09:46 AM
RE: No Access Point - by Tim Curtis - 04-12-2018, 11:54 AM
RE: No Access Point - by LeVolatile - 03-04-2020, 09:57 PM
RE: No Access Point - by paradox - 04-13-2018, 08:43 AM
RE: No Access Point - by rikardo1979 - 04-13-2018, 08:59 AM
RE: No Access Point - by vijapra - 09-04-2018, 09:09 PM
RE: No Access Point - by Tim Curtis - 03-04-2020, 10:50 PM
RE: No Access Point - by 3dcnc - 12-11-2020, 12:24 PM
RE: No Access Point - by Tim Curtis - 12-11-2020, 01:16 PM
RE: No Access Point - by 3dcnc - 12-14-2020, 12:06 PM
RE: No Access Point - by TheOldPresbyope - 12-14-2020, 04:35 PM
RE: No Access Point - by Tim Curtis - 12-14-2020, 04:58 PM
RE: No Access Point - by 3dcnc - 12-16-2020, 11:03 AM
RE: No Access Point - by 3dcnc - 12-16-2020, 07:13 PM

Forum Jump: