06-30-2019, 02:53 PM
Thanks for the fast response. I should have added more detail - I only mentioned the network in passing so my description was rather poor.
My Netgear D7000 has wifi switched off so only supplies wired internet. It is wired to a Netgear Orbi mesh system (in AP mode). This supplies both wired and wifi internet to the majority of my devices.
I have a lot of devices thanks to my use of many RPIs. To help I also use powerlines and the MoOde RPI is wired to the Netgear D7000 via a Netgear powerline 1200.
I have tried using the RPI wifi to connect the network - but I still saw the same error when trying to play the radio.
The RPI is on a static IP address set within the D7000. I have tried DHCP too.
The NAS is also wired directly to the D7000 and is also on a static IP address.
The NAIM (UnitiQute 2) is not connected to the network - I have a Hifiberry Digi+Pro HAT on the RPI and the NAIM just takes the digital output.
This network has always worked without a problem.
Cannot connect to server did sound like a network issue but I cannot find anything wrong.
Hold on ... You're saying that the RPi is connected by LAN cable to the a Netgear router set up in MODEM-mode... can you describe the rest of your set-up: other router, any other device requiring Internet connection (laptop, PC, tablet) and how are they and where are they connected...?
Where are the NAS and the streamer connected?
My Netgear D7000 has wifi switched off so only supplies wired internet. It is wired to a Netgear Orbi mesh system (in AP mode). This supplies both wired and wifi internet to the majority of my devices.
I have a lot of devices thanks to my use of many RPIs. To help I also use powerlines and the MoOde RPI is wired to the Netgear D7000 via a Netgear powerline 1200.
I have tried using the RPI wifi to connect the network - but I still saw the same error when trying to play the radio.
The RPI is on a static IP address set within the D7000. I have tried DHCP too.
The NAS is also wired directly to the D7000 and is also on a static IP address.
The NAIM (UnitiQute 2) is not connected to the network - I have a Hifiberry Digi+Pro HAT on the RPI and the NAIM just takes the digital output.
This network has always worked without a problem.
Cannot connect to server did sound like a network issue but I cannot find anything wrong.
(06-30-2019, 08:47 AM)feh123 Wrote: Hi
I have just installed 5.3.1 on a RPI 3 connected to a WDMyCloud NAS and a Naim streamer. The system plays my music very well.
However, and after searching for solutions online, I cannot get any of the radio stations to play. I get the same on screen error message "curl failed to decode: [radio station ip address] unable to connect to server.
For info I use a Netgear router in modem only mode (it does the DHCP) and the RPI is wired to this router..............snip.....................
Hold on ... You're saying that the RPi is connected by LAN cable to the a Netgear router set up in MODEM-mode... can you describe the rest of your set-up: other router, any other device requiring Internet connection (laptop, PC, tablet) and how are they and where are they connected...?
Where are the NAS and the streamer connected?
