10-01-2019, 06:22 AM
(This post was last modified: 10-01-2019, 08:45 AM by weaver.
Edit Reason: update
)
Hi Tim, I was just going to ask about the isolator as I was looking at the images you posted and couldn’t see it in your setup so thanks for confirming. I was trying to figure out whether, in the case of the SIG the power is better going to the SIG board rather than the isolator in any case. Power is from a Shanti so all clean.
edit: had confirmation that if Isolator is present then connect 3A of Shanti to that.
edit: had confirmation that if Isolator is present then connect 3A of Shanti to that.
