Allo USBridge Signature

[weaver]

Hi,

I'm not sure what version of moOde or Linux kernel Allo is using on the SDCard they bundle with the SIG but applying an in-place update, assuming it completed successfully, would not cause loss of Ethernet function. The update would however, depending on which kernel Allo used, revert the ASIX Ethernet/USB driver to stock. This would just mean that the USB port would run at a lower data rate than with the enhanced ASIX driver.

Did u monitor the in-place update via ssh command moodeutl -l ??

A stock moOde 6.2.0 image followed by the 6.2.1 update should work fine on the SIG. That's what I used for testing and for building the upcoming 6.3.0 release.

-Tim

On 6.2.1 should 24/96 files be fine on SIG over USB or will the USB driver be an issue?
Same file plays fine through Katana but via USB to a Metrum Onyx (should be good for up to 24/384 over USB) I get momentary burbles/drop outs.

Second question, I see in your Isolator-less stack you have extra spacers between SIG and Katana - was this the minimum needed to clear the components on the underside of the Katana board?
 Thank you

Have you tried the USB (UAC2) fix? Below is the ( i ) help.

"Try this fix if experiencing audio glitches with USB High Speed (UAC2) audio devices."


-Tim

I hadn’t tried the USB fix but I have now - no improvement though (the only noticeable difference was that a soft re-boot didn’t work, it hung after trying to restart from moOde so unplugged and then it rebooted properly).
Have also tried SoX resampling options; resampling from 24/96 to 24/96 (just to see) definitely made it worse, 16/44.1 with multi-threading on was the best I got it.