NanoSound DAC Pro anyone?

[TheOldPresbyope]

Perhaps others already know of it but new to me is the NanoSound DAC Pro.
https://nanomesher.com/store/NanoSound-D...-p90621094

This is a RPi HAT with the following claimed specs:

• Texas Instruments PCM5122 DAC
  192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality
  Hardware volume control for best quality using “alsamixer”
• Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator
  
• 1.3" High Resolution OLED Display
  
• Switchable Power Option
  
• Power from a single microUSB port or independently
  
• Raspberry Pi Power switch
  Turn on and Gracefully shut down Raspberry Pi System
• 6 GPIO buttons for Media Control
  
• Infrared Receiver and Remote Control (LIRC compatible)
  
• Works with all Raspberry Pi with 40pin Header (Including Pi 3 Model B+, Pi 3 Model B , Pi 2 Model B, Pi 1 B+)
  

It's being mentioned specifically with respect to Volumio but I see no reason a priori why it would not work equally well with moOde if it works at all.

So far, I have found only fluff pieces about it; no hardcore audiophile assessment. Anyone here try it yet?

Regards,
Kent