[PROBLEM] USB only boot

[Schlauer Det]

Hi Det,

I'm not sure what your screen shot is attempting to show but I assume you have LocalUI turned on in System config.

I have same config, a Pi3 and a 7" Pi-Touch and the UI starts fast and runs smoothly on it. I'm booting from SDCard and not USB stick so maybe try copying the image to an SDCard and see if that makes a difference.

-Tim

Hi Tim,

thanks for the fast reply.  

You were right, the "LocalUI" switch was set to "ON". I was thinking that this is necessary when using the TouchScreen.
After setting it to "OFF" my system hangs at exactly the same point of the boot and start-up procedure as before as shown in the screen shot. Only difference: It now hangs permanently .

My intention is NOT to boot from SDCard since I have a lot of bad experiences with these cards and they are not so easy to change when put into a system consisting of Raspi, TouchScreen and the housing for that stuff.

Further explanation of my build process: Using the Moode OS Builder Version 2.4, I used the same destination for the system as the initial Raspbian boot was made from. The only difference is that I didn't use a SDCard but a USB Stick.

Could you probably give me some more hints where to look for a solution of my problem?
In case this is solved, I will stay with moode and donate for its further development.


Thanks in advance
Det