CamillaDSP

[bitlab]

@zulizu The camilladsp config it fine, don't worry. Only the camillagui can not handle the relative paths.
The moode should handle this by setting absolute paths. I think I found an issue with that the first time an configuraiton is activated.

Can you do the following to see it fix the error:

• go to the moode camilla config page
  
• select as active config the default 'flat'
  
• press save
  
• select as active config the 'quick convolution filter'
  
• press save
  
• open the pipeline editor again to check if the error is gone.