[PROBLEM] Turning parametric equalizer off/on

[PERRLA]

Should the changes to the peq take effect after "saving" or perhaps I'm doing something wrong?  In order for my changes to take effect I must go back to the configure audio page, turn peq off ---set, then select "default" then set again.

My version is 6.7.1

I'm on 7.3 and my changes are applied after I click save.

Thanks, I'll update and give it a try.  Also is the process to update the same as if I were setting up the device from the beginning.  I don't see an "update" button.