CamillaDSP with Allo Piano2.1

[Theswza]

The Chip options config screen in moOde provides the options listed below for the Piano 2.1. These don't require the TI PurePath software, only the Piano 2.1 firmware files which can be downloaded from Allo and installed using their instructions.

Output mode
- Dual-Mono: main DAC outputs L ch and Sub DAC outputs R ch (L/mute mute/R)
- Dual-Stereo: both DAC's output L/R channels (L/R L/R).
- Stereo: all freq to Main L/R, Sub L/R muted.
- Subwoofer: 2.1/2.2 (high freq to Main L/R, low freq to Sub L / Sub L/R).

Subwoofer x-over freq
- Frequency range: 60 - 200 Hz.<br>

Subwoofer volume
- Volume range: 0 - 100%.

Thanks for that Tim.  So I see that I can set up the 2.1 configuration through Moode but will the CamillaDSP IR filters I've created be used as well before the crossover is done by the Piano2.1? Allo's website says filters can be created using PurePath but using CamillaDSP would be much easier.  Thanks