12-30-2022, 02:50 PM
(This post was last modified: 12-30-2022, 02:58 PM by Tim Curtis.)
The Gateway address in the AP mode section is not correct. It should be 0.0.0.0. I'm not sure how Gateway could be set to a completely different network.
As far a the rest of the log goes I don't see anything suspicious.
ETA: I suppose one other thing you could try is to remove the audio HAT just in case it's on-board oscillators are emitting RF in the 2.4GHz band. This was an issue with early hifiberry day pro.
ETA: In addition to removing the audio HAT use an Ethernet or WiFi 5GHz connection instead of AP mode which uses 2.4GHz on default channel 6.
Code:
20221230 120344 worker: wlan0 AP mode started
20221230 120354 worker: wlan0 check 0 for IP address
20221230 120356 worker: wlan0 check 1 for IP address
20221230 120358 worker: wlan0 check 2 for IP address
20221230 120400 worker: IP addr (172.24.1.1)
20221230 120400 worker: Netmask (255.255.255.0)
20221230 120400 worker: Gateway (192.168.1.1)
20221230 120400 worker: Pri DNS (127.0.0.1)
20221230 120400 worker: Domain () As far a the rest of the log goes I don't see anything suspicious.
ETA: I suppose one other thing you could try is to remove the audio HAT just in case it's on-board oscillators are emitting RF in the 2.4GHz band. This was an issue with early hifiberry day pro.
ETA: In addition to removing the audio HAT use an Ethernet or WiFi 5GHz connection instead of AP mode which uses 2.4GHz on default channel 6.
