02-10-2024, 07:53 PM
Dear Notul,
I don't want to cause controversy but perhaps you didn't read my answer carefully - I read and reread the documentation but nowhere did I read that it was necessary to set the parameters in the Pi Imager app as I wrote in my post so it's possible to make a mistake - also as I wrote I had never used Pi Imager but for version 8 Balena etcher.
I don't expect the documentation to be so detailed and once again I thank Tim for his commitment.
For the rest I just hope that my experience and the information I have indicated in my post can be useful to other users - after all, this is what the forum is for.
Cheers.
I don't want to cause controversy but perhaps you didn't read my answer carefully - I read and reread the documentation but nowhere did I read that it was necessary to set the parameters in the Pi Imager app as I wrote in my post so it's possible to make a mistake - also as I wrote I had never used Pi Imager but for version 8 Balena etcher.
I don't expect the documentation to be so detailed and once again I thank Tim for his commitment.
For the rest I just hope that my experience and the information I have indicated in my post can be useful to other users - after all, this is what the forum is for.
Cheers.
