05-04-2024, 09:14 AM
(This post was last modified: 05-04-2024, 10:15 AM by cpunter.
Edit Reason: Extra info added
)
After a recent swap of Digi output HAT, I managed to screw up something because now, I am no longer able to change any of the Audio Output settings. It's stuck at I2S audio device and the last incorrect combination of I2S device and DT overlay that was made before I presume a file got corrupted.
No matter which I2S device or DT overlay I select from the pull down lists, the SET buttons no longer become active.
I have successfully swapped Dig Out HATs and had no problems changing these settings for this Moode install many times over the past few weeks. It's just this last instance that the process seems to have corrupted something.
I installed Moode using RPI Imager direct onto a new SD Card.
Is there anything I can do outside of a complete reinstall?
No matter which I2S device or DT overlay I select from the pull down lists, the SET buttons no longer become active.
I have successfully swapped Dig Out HATs and had no problems changing these settings for this Moode install many times over the past few weeks. It's just this last instance that the process seems to have corrupted something.
I installed Moode using RPI Imager direct onto a new SD Card.
Is there anything I can do outside of a complete reinstall?
