Upcoming moOde 9.0.0 (Bookworm)

[Tim Curtis]

Hi,

Download ISO image
https://moodeaudio.org/test/image_2024-0...4-lite.zip

Pi5
unzipped image_2024-05-08-moode-r900~pre6-arm64-lite.zip
used the official Raspberry Pi imager to burn the iso to the SD card.
-- followed the setup instructions here:  https://github.com/moode-player/moode/bl.../setup.txt

boot the Pi, input the password, and it loads into a command prompt. 
rebooted.
again, command prompt.

I can see the Pi on the network, but nothing happens when I try to access it via IP.
also, I'm not seeing a Moode ssid.

- SSID           Moode
- Password    As set in Network Config screen
- URL           http://moode.local | http://172.24.1.1

Did I miss something?

I don't understand this statement "boot the Pi, input the password, and it loads into a command prompt" 

but from the Setup Guide (below). There are no embedded userid's or passwords in the moode image. This improves the security of the image and is a benefit to everyone.

MOODE OS IMAGE

For improved security the OS image does not contain a userid, WiFi SSID or
Hotspot password, and Secure Shell (SSH) access is disabled.

  1. REQUIRED: The official Raspberry Pi Imager is required to enable SSH,
  create a userid and password and optionally set the host name and WiFi SSID
  and password. If a host name is not set in the Imager then the default
  host name "moode" will be used.

  2. REQUIRED: Userid, password and SSH are required otherwise moOde will not
  function correctly. When enabling SSH, select "Use password authentication"
  which means the password specified for the userid is to be used.

  3. REQUIRED: A Hotspot password is required and is set after first boot
  in the Network Configuration screen. This allows moOde to still be accessable
  if it cannot connect to Ethernet or any configured WiFi SSID's.