Thank you for your donation!
|
moOde on Holo Red
|
06-19-2024, 02:39 PM
(06-19-2024, 02:20 PM)Tim Curtis Wrote: Have you done the required steps in the Setup Guide to prepare the image using the Raspberry Pi Imager? I was unaware you had to use the Raspberry Pi Imager. I guess that needs to be more clearly stated. I used Balana Etcher like I have always used. I am using the official Raspberry Pi Imager now and will report back. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
moOde on Holo Red - by azimuth - 06-19-2024, 02:18 AM
RE: moOde on Holo Red - by azimuth - 06-19-2024, 03:39 AM
RE: moOde on Holo Red - by the_bertrum - 06-19-2024, 07:23 AM
RE: moOde on Holo Red - by azimuth - 06-19-2024, 02:18 PM
RE: moOde on Holo Red - by Tim Curtis - 06-19-2024, 02:20 PM
RE: moOde on Holo Red - by azimuth - 06-19-2024, 02:39 PM
RE: moOde on Holo Red - by TheOldPresbyope - 06-19-2024, 03:04 PM
RE: moOde on Holo Red - by Tim Curtis - 06-19-2024, 03:28 PM
RE: moOde on Holo Red - by azimuth - 06-19-2024, 03:28 PM
RE: moOde on Holo Red - by Tim Curtis - 06-19-2024, 03:29 PM
RE: moOde on Holo Red - by azimuth - 06-19-2024, 04:42 PM
RE: moOde on Holo Red - by TheOldPresbyope - 06-20-2024, 03:30 PM
RE: moOde on Holo Red - by azimuth - 06-20-2024, 03:46 PM
RE: moOde on Holo Red - by philrandal - 06-20-2024, 05:47 PM
RE: moOde on Holo Red - by azimuth - 06-20-2024, 07:26 PM
RE: moOde on Holo Red - by TheOldPresbyope - 06-20-2024, 05:54 PM
|
