[SOLVED] Fresh install Pi-4 rev 1.5 not joining network

[hoverdonkey]

I've flashed the SD card so many times doing this that it must be really well burned-in now... it's gonna sound fantastic when I do eventually get Moode working on it!

[Tim Curtis]

I've flashed the SD card so many times doing this that it must be really well burned-in now... it's gonna sound fantastic when I do eventually get Moode working on it!

lol, like a well aged Whiskey ;-)

[hoverdonkey]

Ok thanks for all the testing :-) Not obvious what was going on.

Btw is your Pi-4 a revision 1.5 board? Try the command below to print the revision info.

Code:

sudo /var/www/command/pirev.py

What, you mean I have flash Bullseye back AGAIN? 

Just kidding, on it now...

[hoverdonkey]

Ok thanks for all the testing :-) Not obvious what was going on.

Btw is your Pi-4 a revision 1.5 board? Try the command below to print the revision info.

Code:

sudo /var/www/command/pirev.py

Errr...

pi@raspberrypi:~ $ sudo /var/www/command/pirev.py
sudo: /var/www/command/pirev.py: command not found

[hoverdonkey]

Deleted dupe post, sorry.

[Tim Curtis]

Oops I'm still thinking Buster and moOde image

On fresh Bullseye try below

Code:

cat /proc/cpuinfo | grep Model

[hoverdonkey]

Oops I'm still thinking Buster and moOde image

On fresh Bullseye try below

Code:

cat /proc/cpuinfo | grep Model

pi@raspberrypi:~ $ cat /proc/cpuinfo | grep Model
Model           : Raspberry Pi 4 Model B Rev 1.5

[Tim Curtis]

Great thanks :-)

Looks like revision 1.5 board has some specific requirements as far as firmware and OS goes. There are prolly posts about this on the Pi Forums.

Never a dull moment in the Pi space ;-)

[hoverdonkey]

Thanks for sticking with it, much appreciated

[starbender]

Same issue here.
New Pi4 board. Tried both moode and volumio.
Wired network.
Both of them cannot boot.
Green led blinks 4 long 4 short and repeats.
Looks like board is not compatible with moode and volumio images.

ps. picore works fine.